Categories | TFT LCD Display |
---|---|
Brand Name: | ESEN |
Model Number: | T-220BI4501 |
Certification: | ISO9001/ISO14001 |
Place of Origin: | Shenzhen China |
MOQ: | 500 PCS |
Price: | can be negotiated |
Payment Terms: | L/C,T/T |
Supply Ability: | 300K/mth |
Delivery Time: | 5~14 working days |
Packaging Details: | Cartons, Capboard, EPE, Blister Tray. |
Size: | 2.2-Inch |
Dimension: | 38.68(W)* 55.14(H) * 2.35(T) |
Active Area: | 33.84* 45.12 mm |
Number OfDots: | 240 * RGB * 320 |
LCD Type: | a-Si TFT |
Viewing Direction: | 12 o'clock |
Driver IC: | ST7789V2-G4 |
Interface Type: | MCU |
Operating Temperature: | -20℃~ 70℃ |
Storage Temperature: | -30℃~ 80℃ |
Backlight Type: | 4 LEDs |
Luminance: | customizable |
POL: | UP 0.22/below 0.22 |
Custom Service: | FPC, CTP (capacitive touch panel), RTP (resistive touch panel), pin definition, packing, HD-MI board |
2.2 Inch TFT LCD Module 240*320 MCU Standard TFT LCD Display
MechanicalDrawing
Pin Assignments
NO | Symbol | Description |
1 | GND | Ground |
2-5 | NC | NC |
6 | IMO | I/O choose |
7-9 | NC | NC |
10 | RESET | Reset pin |
11-14 | NC | NC |
15-22 | DB17-DB10 | Data Bus |
23 | NC | NC |
24-31 | DB8-DB1 | Data Bus |
32-34 | NC | NC |
35 | RD | Read signal, rising-edge-active. |
36 | WR | Write signal, rising-edge-trigger. |
37 | RS | Data/Command register address. |
38 | CS | Chip enable, Low-active. |
39 | VCC | POWER SUPPLY |
40 | VCC | POWER SUPPLY |
41 | LEDK | BACKLIGHT CATHODE |
42 | LEDA | BACKLIGHT ANODE |
43 | LEDA | BACKLIGHT ANODE |
44 | LEDA | BACKLIGHT ANODE |
45 | GND | Ground |
Storage Method
1.Store in an ambient temperature of 23°C±5°C, and in a relative humidity of 55%±15%. Don't exceed 12 months and expose to sunlight or fluorescent light.
2.Store in a clean environment, free from dust, active gas, and solvent.
3 LCM module is stored in warehouse,Store in antistatic container, There may be air bubbles between the protective film on the surface of polarizer and polarizer. It can only be found under LED light, Before production,IQC should be inspected directly by LED light,If residual traces are found, alcohol should be used to wipe them.
![]() |