Intelligent tensile strength tester for Vertical Enameling machine

Performance Characteristics of Product
◆Executive standard: GB/T4074.3-2008/IEC60851-3; Inspection standard: JB/T4279.3-2008
◆Applicable to metal wires with pulling strength ≤3000N;
◆Test process would be automatically completed and, after user inputting wire size of samples to be measured, the instrument would automatically calculate tensile strength;
◆Application of matured advanced human-computer interface would provide a hint for test operating procedure and display test results of elongation, pulling strength and tensile strength;
◆Two test modes are available: Micro-fine wire and medium & large wire;
◆50N-3000N sensors can be switched over arbitrarily;
◆Automatic outrange protection for instrument;
◆The application of software facilitates instrument’s on-line operation and control as well as data analysis and comparison, and allows for display of stress-strain curve chart of 15 samples in different colors;
◆Automatically calculate the average of each test result of less than fifteen samples;
◆Number and save test results and corresponding curves automatically in chronological order;
◆Report of test results can be generated and printed out;
◆Instrument is provided with sensor self-calibration function and equipped with standard weight for calibration;
◆Servo motor and high precision ball screw is used;
◆Clamps are designed on the basis of characteristics of wires and can be conveniently loaded and unloaded with samples;
◆All test data can be automatically transmitted to upper computer, and be saved and analyzed by DMS-15 quality inspection data management system for enameled winding wire.

Major Technical Parameters

●Standard configuration:
◆Microwire:
One 50N and 500N sensor for each;
One 20N standard weight;
One SC-5E software CD;
◆Medium and large wires:
One 500N and 3000N sensor for each;
One SC-5E software CD;
●Sensors available: 100N, 200N, 1000N and 2000N
●Optional Model: SC-5D elongation and tensile strength tester (desktop)