WS2811 digital strip DC5V 10LEDs/m 10 Image Pixel dream led strip

Connection:
1) Signal wire: DC+, DIN, GND
2) DC+ and GND connect to power supplier; DIN and GND connect to controller
3) Relative Controller: SPI controller support ws2811; when use DMX decorder, can connect to DMX system
4) Support online control

Installation Notice:
1) Make sure the connection is correct according to the diagram
2) Pay attention to the parameters limit of voltage. DO NOT run over the peak value
3) Keep the surface of installation clean and smooth avoid breaking off
4) Avoiding the crook area just the position of LED and other components, in order to protect the product and extend the life span of the product