The line for the production of SIP-panels
1. Table panel assembly .
2. Hydraulic press .
3. Table for the reception of the finished panel .
4. Apparatus for applying adhesive .
5. Machine cutting panels .
6. Machine sample heater .
Description of the technological process of SIP panels
On the table is automatically installed on the assembly of the
stops are placed two sheets of OSB up to 3 meters, and then to glue
them using a setup that moves on rails along the table,
automatically applied glue and water mist. At the bottom OSB sheets
are stacked Styrofoam plate and also on the plate is applied to the
adhesive layer that covers the top sheets of OSB.
Geometry CIP panels defined stops, for which two operators are
three sets of one panel member, thereby forming around the
perimeter of the locking panel. Further, these two panels are two
similarly collected. So, in the raw form four panels are ready!
When you press the button pressed, the following occurs
automatically. Stops move aside and free movement in the way the
press four (raw) panels at the same time pressed four (ready)
panels rolled out on the reception table.
In the equipment is based on the principle of continuous
employment: while one package glued panels, at this time working to
assemble a new package of panels.
When building a house, usually two thirds of the total CIP panels
used without cutting.
Cutting the remaining one-third of the panels produced using
cutting machine, which has a special saw blade, allowing the
thickest cut a panel at an angle of 45to the vertical. After
cutting on some panels need to select the slot (lock) for this
purpose and is the last machine - the machine polystyrene sample.