The MPC6585 controller is a stand-alone close-loop control card
specially designed for the servo control system of laser engraving
and cutting machines. User can edit graphics, set parameters, and
optimize path to develop a process file using computer. Copy the
process file to USB stick, and load
it to MPC6585 through the USB interface in the controller. Then Run
the processing work with PAD03 control panel.
MPC6585is upgraded from MPC6535 Break-point resume in both engraving and
Direct-print from CorelDraw, WORD file.
1. Break-point resume in both engraving and cutting jobs.
2. Supports direct-print in AutoCAD, notePAD, word and CorelDRAW.
3.Stand-Alone Motion Controller
4. Apply DSP and FPGA technologies
5. 3-axis card for stepper motors or digital servo motors
6. Trapezoidal or S-curve drive of slow-up/slow down control
7. Switch interfaces such as origin and limit
8.1-CH laser power on/off control output
9.1-CH laser PWM control output
10. Support 1or 2-CH independent power analog output
11. PWM preheat control
12.Uncapping protection 12.Mono 24V DC power
13.RS232 applicable for mainstream industrial touchscreen
supporting Modbus communication protocol
14. 128M embedded memory
16.Download data with USB flash disk or USB cable
17.USB transfer speed up to 500Kb/s
18. Position compare output
19. Look-ahead algorithm and trajectory fitting algorithm
21. Look-ahead function.